nand_wait_ready(mtd);
}
+static void nand_ccs_delay(struct nand_chip *chip)
+{
+ /*
+ * The controller already takes care of waiting for tCCS when the RNDIN
+ * or RNDOUT command is sent, return directly.
+ */
+ if (!(chip->options & NAND_WAIT_TCCS))
+ return;
+
+ /*
+ * Wait tCCS_min if it is correctly defined, otherwise wait 500ns
+ * (which should be safe for all NANDs).
+ */
+ if (chip->data_interface && chip->data_interface->timings.sdr.tCCS_min)
+ ndelay(chip->data_interface->timings.sdr.tCCS_min / 1000);
+ else
+ ndelay(500);
+}
+
/**
* nand_command_lp - [DEFAULT] Send command to NAND large page device
* @mtd: MTD device structure
case NAND_CMD_ERASE1:
case NAND_CMD_ERASE2:
case NAND_CMD_SEQIN:
- case NAND_CMD_RNDIN:
case NAND_CMD_STATUS:
return;
+ case NAND_CMD_RNDIN:
+ nand_ccs_delay(chip);
+ return;
+
case NAND_CMD_RESET:
if (chip->dev_ready)
break;
NAND_NCE | NAND_CLE | NAND_CTRL_CHANGE);
chip->cmd_ctrl(mtd, NAND_CMD_NONE,
NAND_NCE | NAND_CTRL_CHANGE);
+
+ nand_ccs_delay(chip);
return;
case NAND_CMD_READ0:
__func__, buf);
read_retry:
- chip->cmdfunc(mtd, NAND_CMD_READ0, 0x00, page);
+ if (nand_standard_page_accessors(&chip->ecc))
+ chip->cmdfunc(mtd, NAND_CMD_READ0, 0x00, page);
/*
* Now read the page into the buffer. Absent an error,
else
subpage = 0;
- chip->cmdfunc(mtd, NAND_CMD_SEQIN, 0x00, page);
+ if (nand_standard_page_accessors(&chip->ecc))
+ chip->cmdfunc(mtd, NAND_CMD_SEQIN, 0x00, page);
if (unlikely(raw))
status = chip->ecc.write_page_raw(mtd, chip, buf,
if (!cached || !NAND_HAS_CACHEPROG(chip)) {
- chip->cmdfunc(mtd, NAND_CMD_PAGEPROG, -1, -1);
+ if (nand_standard_page_accessors(&chip->ecc))
+ chip->cmdfunc(mtd, NAND_CMD_PAGEPROG, -1, -1);
status = chip->waitfunc(mtd, chip);
/*
* See if operation failed and additional status checks are
return nand_block_markbad_lowlevel(mtd, ofs);
}
+/**
+ * nand_max_bad_blocks - [MTD Interface] Max number of bad blocks for an mtd
+ * @mtd: MTD device structure
+ * @ofs: offset relative to mtd start
+ * @len: length of mtd
+ */
+static int nand_max_bad_blocks(struct mtd_info *mtd, loff_t ofs, size_t len)
+{
+ struct nand_chip *chip = mtd_to_nand(mtd);
+ u32 part_start_block;
+ u32 part_end_block;
+ u32 part_start_die;
+ u32 part_end_die;
+
+ /*
+ * max_bb_per_die and blocks_per_die used to determine
+ * the maximum bad block count.
+ */
+ if (!chip->max_bb_per_die || !chip->blocks_per_die)
+ return -ENOTSUPP;
+
+ /* Get the start and end of the partition in erase blocks. */
+ part_start_block = mtd_div_by_eb(ofs, mtd);
+ part_end_block = mtd_div_by_eb(len, mtd) + part_start_block - 1;
+
+ /* Get the start and end LUNs of the partition. */
+ part_start_die = part_start_block / chip->blocks_per_die;
+ part_end_die = part_end_block / chip->blocks_per_die;
+
+ /*
+ * Look up the bad blocks per unit and multiply by the number of units
+ * that the partition spans.
+ */
+ return chip->max_bb_per_die * (part_end_die - part_start_die + 1);
+}
+
/**
* nand_onfi_set_features- [REPLACEABLE] set features for ONFI nand
* @mtd: MTD device structure
chip->chipsize *= (uint64_t)mtd->erasesize * p->lun_count;
chip->bits_per_cell = p->bits_per_cell;
+ chip->max_bb_per_die = le16_to_cpu(p->bb_per_lun);
+ chip->blocks_per_die = le32_to_cpu(p->blocks_per_lun);
+
if (onfi_feature(chip) & ONFI_FEATURE_16_BIT_BUS)
*busw = NAND_BUSWIDTH_16;
else
/*
* Get the flash and manufacturer id and lookup if the type is supported.
*/
-static struct nand_flash_dev *nand_get_flash_type(struct mtd_info *mtd,
- struct nand_chip *chip,
- int *maf_id, int *dev_id,
- struct nand_flash_dev *type)
+static int nand_get_flash_type(struct mtd_info *mtd, struct nand_chip *chip,
+ int *maf_id, int *dev_id,
+ struct nand_flash_dev *type)
{
int busw;
int i, maf_idx;
if (id_data[0] != *maf_id || id_data[1] != *dev_id) {
pr_info("second ID read did not match %02x,%02x against %02x,%02x\n",
*maf_id, *dev_id, id_data[0], id_data[1]);
- return ERR_PTR(-ENODEV);
+ return -ENODEV;
}
if (!type)
}
if (!type->name)
- return ERR_PTR(-ENODEV);
+ return -ENODEV;
if (!mtd->name)
mtd->name = type->name;
pr_warn("bus width %d instead %d bit\n",
(chip->options & NAND_BUSWIDTH_16) ? 16 : 8,
busw ? 16 : 8);
- return ERR_PTR(-EINVAL);
+ return -EINVAL;
}
nand_decode_bbm_options(mtd, chip, id_data);
pr_info("%d MiB, %s, erase size: %d KiB, page size: %d, OOB size: %d\n",
(int)(chip->chipsize >> 20), nand_is_slc(chip) ? "SLC" : "MLC",
mtd->erasesize >> 10, mtd->writesize, mtd->oobsize);
- return type;
+ return 0;
}
static const char * const nand_ecc_modes[] = {
{
int i, nand_maf_id, nand_dev_id;
struct nand_chip *chip = mtd_to_nand(mtd);
- struct nand_flash_dev *type;
int ret;
ret = nand_dt_init(chip);
nand_set_defaults(chip, chip->options & NAND_BUSWIDTH_16);
/* Read the flash type */
- type = nand_get_flash_type(mtd, chip, &nand_maf_id,
- &nand_dev_id, table);
-
- if (IS_ERR(type)) {
+ ret = nand_get_flash_type(mtd, chip, &nand_maf_id, &nand_dev_id, table);
+ if (ret) {
if (!(chip->options & NAND_SCAN_SILENT_NODEV))
pr_warn("No NAND device found\n");
chip->select_chip(mtd, -1);
- return PTR_ERR(type);
+ return ret;
}
/* Initialize the ->data_interface field. */
return corr >= ds_corr && ecc->strength >= chip->ecc_strength_ds;
}
+static bool invalid_ecc_page_accessors(struct nand_chip *chip)
+{
+ struct nand_ecc_ctrl *ecc = &chip->ecc;
+
+ if (nand_standard_page_accessors(ecc))
+ return false;
+
+ /*
+ * NAND_ECC_CUSTOM_PAGE_ACCESS flag is set, make sure the NAND
+ * controller driver implements all the page accessors because
+ * default helpers are not suitable when the core does not
+ * send the READ0/PAGEPROG commands.
+ */
+ return (!ecc->read_page || !ecc->write_page ||
+ !ecc->read_page_raw || !ecc->write_page_raw ||
+ (NAND_HAS_SUBPAGE_READ(chip) && !ecc->read_subpage) ||
+ (NAND_HAS_SUBPAGE_WRITE(chip) && !ecc->write_subpage &&
+ ecc->hwctl && ecc->calculate));
+}
+
/**
* nand_scan_tail - [NAND Interface] Scan for the NAND device
* @mtd: MTD device structure
!(chip->bbt_options & NAND_BBT_USE_FLASH)))
return -EINVAL;
+ if (invalid_ecc_page_accessors(chip)) {
+ pr_err("Invalid ECC page accessors setup\n");
+ return -EINVAL;
+ }
+
if (!(chip->options & NAND_OWN_BUFFERS)) {
nbuf = kzalloc(sizeof(*nbuf) + mtd->writesize
+ mtd->oobsize * 3, GFP_KERNEL);
mtd->_block_isreserved = nand_block_isreserved;
mtd->_block_isbad = nand_block_isbad;
mtd->_block_markbad = nand_block_markbad;
+ mtd->_max_bad_blocks = nand_max_bad_blocks;
mtd->writebufsize = mtd->writesize;
/*
projects / linux.git / blobdiff