* with the get_key() callback, must be in little endian,
* length given by @seq_len.
* @seq_len: length of @seq.
+ * @mode: key install mode (RX_TX, NO_TX or SET_TX)
*/
struct key_params {
const u8 *key;
int key_len;
int seq_len;
u32 cipher;
+ enum nl80211_key_mode mode;
};
/**
STATION_PARAM_APPLY_UAPSD = BIT(0),
STATION_PARAM_APPLY_CAPABILITY = BIT(1),
STATION_PARAM_APPLY_PLINK_STATE = BIT(2),
+ STATION_PARAM_APPLY_STA_TXPOWER = BIT(3),
+};
+
+/**
+ * struct sta_txpwr - station txpower configuration
+ *
+ * Used to configure txpower for station.
+ *
+ * @power: tx power (in dBm) to be used for sending data traffic. If tx power
+ * is not provided, the default per-interface tx power setting will be
+ * overriding. Driver should be picking up the lowest tx power, either tx
+ * power per-interface or per-station.
+ * @type: In particular if TPC %type is NL80211_TX_POWER_LIMITED then tx power
+ * will be less than or equal to specified from userspace, whereas if TPC
+ * %type is NL80211_TX_POWER_AUTOMATIC then it indicates default tx power.
+ * NL80211_TX_POWER_FIXED is not a valid configuration option for
+ * per peer TPC.
+ */
+struct sta_txpwr {
+ s16 power;
+ enum nl80211_tx_power_setting type;
};
/**
const struct ieee80211_he_cap_elem *he_capa;
u8 he_capa_len;
u16 airtime_weight;
+ struct sta_txpwr txpwr;
};
/**
* @fcs_err_count: number of packets (MPDUs) received from this station with
* an FCS error. This counter should be incremented only when TA of the
* received packet with an FCS error matches the peer MAC address.
+ * @airtime_link_metric: mesh airtime link metric.
*/
struct station_info {
u64 filled;
u32 rx_mpdu_count;
u32 fcs_err_count;
+
+ u32 airtime_link_metric;
};
#if IS_ENABLED(CONFIG_CFG80211)
* @bssid: BSSID to be matched; may be all-zero BSSID in case of SSID match
* or no match (RSSI only)
* @rssi_thold: don't report scan results below this threshold (in s32 dBm)
+ * @per_band_rssi_thold: Minimum rssi threshold for each band to be applied
+ * for filtering out scan results received. Drivers advertize this support
+ * of band specific rssi based filtering through the feature capability
+ * %NL80211_EXT_FEATURE_SCHED_SCAN_BAND_SPECIFIC_RSSI_THOLD. These band
+ * specific rssi thresholds take precedence over rssi_thold, if specified.
+ * If not specified for any band, it will be assigned with rssi_thold of
+ * corresponding matchset.
*/
struct cfg80211_match_set {
struct cfg80211_ssid ssid;
u8 bssid[ETH_ALEN];
s32 rssi_thold;
+ s32 per_band_rssi_thold[NUM_NL80211_BANDS];
};
/**
struct cfg80211_pmsr_request_peer peers[];
};
+/**
+ * struct cfg80211_update_owe_info - OWE Information
+ *
+ * This structure provides information needed for the drivers to offload OWE
+ * (Opportunistic Wireless Encryption) processing to the user space.
+ *
+ * Commonly used across update_owe_info request and event interfaces.
+ *
+ * @peer: MAC address of the peer device for which the OWE processing
+ * has to be done.
+ * @status: status code, %WLAN_STATUS_SUCCESS for successful OWE info
+ * processing, use %WLAN_STATUS_UNSPECIFIED_FAILURE if user space
+ * cannot give you the real status code for failures. Used only for
+ * OWE update request command interface (user space to driver).
+ * @ie: IEs obtained from the peer or constructed by the user space. These are
+ * the IEs of the remote peer in the event from the host driver and
+ * the constructed IEs by the user space in the request interface.
+ * @ie_len: Length of IEs in octets.
+ */
+struct cfg80211_update_owe_info {
+ u8 peer[ETH_ALEN] __aligned(2);
+ u16 status;
+ const u8 *ie;
+ size_t ie_len;
+};
+
/**
* struct cfg80211_ops - backend description for wireless configuration
*
* Statistics should be cumulative, currently no way to reset is provided.
* @start_pmsr: start peer measurement (e.g. FTM)
* @abort_pmsr: abort peer measurement
+ *
+ * @update_owe_info: Provide updated OWE info to driver. Driver implementing SME
+ * but offloading OWE processing to the user space will get the updated
+ * DH IE through this interface.
+ *
+ * @probe_mesh_link: Probe direct Mesh peer's link quality by sending data frame
+ * and overrule HWMP path selection algorithm.
*/
struct cfg80211_ops {
int (*suspend)(struct wiphy *wiphy, struct cfg80211_wowlan *wow);
struct cfg80211_pmsr_request *request);
void (*abort_pmsr)(struct wiphy *wiphy, struct wireless_dev *wdev,
struct cfg80211_pmsr_request *request);
+ int (*update_owe_info)(struct wiphy *wiphy, struct net_device *dev,
+ struct cfg80211_update_owe_info *owe_info);
+ int (*probe_mesh_link)(struct wiphy *wiphy, struct net_device *dev,
+ const u8 *buf, size_t len);
};
/*
u64_to_ether_addr(new_bssid_u64, new_bssid);
}
+/**
+ * cfg80211_is_element_inherited - returns if element ID should be inherited
+ * @element: element to check
+ * @non_inherit_element: non inheritance element
+ */
+bool cfg80211_is_element_inherited(const struct element *element,
+ const struct element *non_inherit_element);
+
+/**
+ * cfg80211_merge_profile - merges a MBSSID profile if it is split between IEs
+ * @ie: ies
+ * @ielen: length of IEs
+ * @mbssid_elem: current MBSSID element
+ * @sub_elem: current MBSSID subelement (profile)
+ * @merged_ie: location of the merged profile
+ * @max_copy_len: max merged profile length
+ */
+size_t cfg80211_merge_profile(const u8 *ie, size_t ielen,
+ const struct element *mbssid_elem,
+ const struct element *sub_elem,
+ u8 *merged_ie, size_t max_copy_len);
+
/**
* enum cfg80211_bss_frame_type - frame type that the BSS data came from
* @CFG80211_BSS_FTYPE_UNKNOWN: driver doesn't know whether the data is
#define wiphy_WARN(wiphy, format, args...) \
WARN(1, "wiphy: %s\n" format, wiphy_name(wiphy), ##args);
+/**
+ * cfg80211_update_owe_info_event - Notify the peer's OWE info to user space
+ * @netdev: network device
+ * @owe_info: peer's owe info
+ * @gfp: allocation flags
+ */
+void cfg80211_update_owe_info_event(struct net_device *netdev,
+ struct cfg80211_update_owe_info *owe_info,
+ gfp_t gfp);
+
#endif /* __NET_CFG80211_H */
projects / linux.git / blobdiff