net sched actions: Complete the JUMPX opcode

net sched actions: Complete the JUMPX opcode

per discussion at netconf/netdev:
When we have an action that is capable of branching (example a policer),
we can achieve a continuation of the action graph by programming a
"continue" where we find an exact replica of the same filter rule with a lower
priority and the remainder of the action graph. When you have 100s of thousands
of filters which require such a feature it gets very inefficient to do two
lookups.

This patch completes a leftover feature of action codes. Its time has come.

Example below where a user labels packets with a different skbmark on ingress
of a port depending on whether they have/not exceeded the configured rate.
This mark is then used to make further decisions on some egress port.

 #rate control, very low so we can easily see the effect
sudo $TC actions add action police rate 1kbit burst 90k \
conform-exceed pipe/jump 2 index 10
 # skbedit index 11 will be used if the user conforms
sudo $TC actions add action skbedit mark 11 ok index 11
 # skbedit index 12 will be used if the user does not conform
sudo $TC actions add action skbedit mark 12 ok index 12

 #lets bind the user ..
sudo $TC filter add dev $ETH parent ffff: protocol ip prio 8 u32 \
match ip dst 127.0.0.8/32 flowid 1:10 \
action police index 10 \
action skbedit index 11 \
action skbedit index 12

 #run a ping -f and see what happens..
 #
jhs@foobar:~$ sudo $TC -s filter ls dev $ETH parent ffff: protocol ip
filter pref 8 u32
filter pref 8 u32 fh 800: ht divisor 1
filter pref 8 u32 fh 800::800 order 2048 key ht 800 bkt 0 flowid 1:10  (rule hit 2800 success 1005)
  match 7f000008/ffffffff at 16 (success 1005 )
	action order 1:  police 0xa rate 1Kbit burst 23440b mtu 2Kb action pipe/jump 2 overhead 0b
	ref 2 bind 1 installed 207 sec used 122 sec
	Action statistics:
	Sent 84420 bytes 1005 pkt (dropped 0, overlimits 721 requeues 0)
	backlog 0b 0p requeues 0

	action order 2:  skbedit mark 11 pass
	 index 11 ref 2 bind 1 installed 204 sec used 122 sec
 	Action statistics:
	Sent 60564 bytes 721 pkt (dropped 0, overlimits 0 requeues 0)
	backlog 0b 0p requeues 0

	action order 3:  skbedit mark 12 pass
	 index 12 ref 2 bind 1 installed 201 sec used 122 sec
 	Action statistics:
	Sent 23856 bytes 284 pkt (dropped 0, overlimits 0 requeues 0)
	backlog 0b 0p requeues 0

Not bad, about 28% non-conforming packets..

Signed-off-by: Jamal Hadi Salim <jhs@mojatatu.com>
Signed-off-by: David S. Miller <davem@davemloft.net>