Now that the i2c-bcm-iproc driver has been fixed to permit reading more
than 63 bytes in a single transaction with commit
fd01eecdf959 ("i2c:
iproc: Fix i2c master read more than 63 bytes") we no longer need to
bitbang i2c over GPIOs which was necessary before to allow the
PHYLINK/SFP subsystems to read SFP modules.
Reviewed-by: Ray Jui <ray.jui@broadcom.com>
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
priority = <200>;
};
- /* Hardware I2C block cannot do more than 63 bytes per transfer,
- * which would prevent reading from a SFP's EEPROM (256 byte).
- */
- i2c1: i2c {
- compatible = "i2c-gpio";
- sda-gpios = <&gpioa 5 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
- scl-gpios = <&gpioa 4 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
- };
-
sfp: sfp {
compatible = "sff,sfp";
- i2c-bus = <&i2c1>;
+ i2c-bus = <&i2c0>;
mod-def0-gpios = <&gpioa 28 GPIO_ACTIVE_LOW>;
los-gpios = <&gpioa 24 GPIO_ACTIVE_HIGH>;
tx-fault-gpios = <&gpioa 30 GPIO_ACTIVE_HIGH>;
};
};
+&i2c0 {
+ status = "okay";
+};
+
&amac0 {
status = "okay";
};