TRM [1] mentions that we need to power up
PCIESS_PHY_TX and PCIESS_PHY_RX before configuring
PCIe_PHY_RX SCP settings.
See "Table 26-81. PCIePHY Subsystem Low-Level Programming Sequence".
[1] DRA75x, DRA74x TRM - http://www.ti.com/lit/ug/sprui30f/sprui30f.pdf
Signed-off-by: Roger Quadros <rogerq@ti.com>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
return ret;
}
+static void ti_pipe3_calibrate(struct ti_pipe3 *phy);
+
static int ti_pipe3_power_on(struct phy *x)
{
u32 val;
mask, val);
}
+ if (phy->mode == PIPE3_MODE_PCIE)
+ ti_pipe3_calibrate(phy);
+
return 0;
}
val = 0x96 << OMAP_CTRL_PCIE_PCS_DELAY_COUNT_SHIFT;
ret = regmap_update_bits(phy->pcs_syscon, phy->pcie_pcs_reg,
PCIE_PCS_MASK, val);
- if (ret)
- return ret;
-
- ti_pipe3_calibrate(phy);
-
- return 0;
+ return ret;
}
/* Bring it out of IDLE if it is IDLE */