scsi: smartpqi: properly set both the DMA mask and the coherent DMA mask

When SME is enabled, the smartpqi driver won't work on the HP DL385 G10
machine, which causes the failure of kernel boot because it fails to
allocate pqi error buffer. Please refer to the kernel log:
....
[    9.431749] usbcore: registered new interface driver uas
[    9.441524] Microsemi PQI Driver (v1.1.4-130)
[    9.442956] i40e 0000:04:00.0: fw 6.70.48768 api 1.7 nvm 10.2.5
[    9.447237] smartpqi 0000:23:00.0: Microsemi Smart Family Controller found
         Starting dracut initqueue hook...
[  OK  ] Started Show Plymouth Boot Scre[    9.471654] Broadcom NetXtreme-C/E driver bnxt_en v1.9.1
en.
[  OK  ] Started Forward Password Requests to Plymouth Directory Watch.
[[0;[    9.487108] smartpqi 0000:23:00.0: failed to allocate PQI error buffer
....
[  139.050544] dracut-initqueue[949]: Warning: dracut-initqueue timeout - starting timeout scripts
[  139.589779] dracut-initqueue[949]: Warning: dracut-initqueue timeout - starting timeout scripts

Basically, the fact that the coherent DMA mask value wasn't set caused the
driver to fall back to SWIOTLB when SME is active.

For correct operation, lets call the dma_set_mask_and_coherent() to
properly set the mask for both streaming and coherent, in order to inform
the kernel about the devices DMA addressing capabilities.

Signed-off-by: Lianbo Jiang <lijiang@redhat.com>
Acked-by: Don Brace <don.brace@microsemi.com>
Tested-by: Don Brace <don.brace@microsemi.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

diff --git a/drivers/scsi/smartpqi/smartpqi_init.c b/drivers/scsi/smartpqi/smartpqi_init.c
index b17761eafca91eeb8ff68126567f46f4942184f6..d6be4e8f4a8f0852aac445d2193da9b4ed7b8c96 100644 (file)
--- a/drivers/scsi/smartpqi/smartpqi_init.c
+++ b/drivers/scsi/smartpqi/smartpqi_init.c
@@ -7291,7 +7291,7 @@ static int pqi_pci_init(struct pqi_ctrl_info *ctrl_info)
        else
                mask = DMA_BIT_MASK(32);
 
-       rc = dma_set_mask(&ctrl_info->pci_dev->dev, mask);
+       rc = dma_set_mask_and_coherent(&ctrl_info->pci_dev->dev, mask);
        if (rc) {
                dev_err(&ctrl_info->pci_dev->dev, "failed to set DMA mask\n");
                goto disable_device;