Some interrupts properties are given '0' as the flags argument or no
flags argument at all.
Change them to use the appropriate interrupt flags.
Signed-off-by: Lothar Waßmann <LW@KARO-electronics.de>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_tsc2007>;
interrupt-parent = <&gpio3>;
- interrupts = <26 0>;
+ interrupts = <26 IRQ_TYPE_EDGE_FALLING>;
gpios = <&gpio3 26 GPIO_ACTIVE_LOW>;
ti,x-plate-ohms = <660>;
wakeup-source;
phy0: ethernet-phy@0 {
interrupt-parent = <&gpio2>;
- interrupts = <4>;
+ interrupts = <4 IRQ_TYPE_EDGE_FALLING>;
device_type = "ethernet-phy";
};
};
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_ds1339>;
interrupt-parent = <&gpio4>;
- interrupts = <20 0>;
+ interrupts = <20 IRQ_TYPE_EDGE_FALLING>;
trickle-resistor-ohms = <250>;
trickle-diode-disable;
};