dt-bindings: Add PCIe supports-clkreq property

Some host controllers need to know the existence of clkreq signal routing
to downstream devices to be able to advertise low power features like
ASPM L1 substates. Without clkreq signal routing being present, enabling
ASPM L1 substates might lead to downstream devices being disconnected
from the bus. Hence a new device tree property 'supports-clkreq' is added
to make such host controllers aware of clkreq signal routing to
downstream devices.

Signed-off-by: Vidya Sagar <vidyas@nvidia.com>
Signed-off-by: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Reviewed-by: Thierry Reding <treding@nvidia.com>

diff --git a/Documentation/devicetree/bindings/pci/pci.txt b/Documentation/devicetree/bindings/pci/pci.txt
index 2a5d91024059c4dd912a04bc858672e31ff22a6d..29bcbd88f457df6466a30645306ea6ca4e8187ca 100644 (file)
--- a/Documentation/devicetree/bindings/pci/pci.txt
+++ b/Documentation/devicetree/bindings/pci/pci.txt
@@ -27,6 +27,11 @@ driver implementation may support the following properties:
 - reset-gpios:
    If present this property specifies PERST# GPIO. Host drivers can parse the
    GPIO and apply fundamental reset to endpoints.
+- supports-clkreq:
+   If present this property specifies that CLKREQ signal routing exists from
+   root port to downstream device and host bridge drivers can do programming
+   which depends on CLKREQ signal existence. For example, programming root port
+   not to advertise ASPM L1 Sub-States support if there is no CLKREQ signal.
 
 PCI-PCI Bridge properties
 -------------------------