dt-bindings: serial/rs485: make rs485-rts-delay optional

There are a few device trees that specify one of the already optional
properties without also having the up to now required property
rs485-rts-delay. Additionally there is no technical reason to require
rs485-rts-delay and that's also what most drivers implement.

So give existing users and implementers a blessing and document
rs485-rts-delay as optional.

Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

diff --git a/Documentation/devicetree/bindings/serial/rs485.txt b/Documentation/devicetree/bindings/serial/rs485.txt
index 32b1fa1f2a5b8dec1eca195f1fea93528155728b..b8415936dfdbc59cdf8c6027337603579d3e9403 100644 (file)
--- a/Documentation/devicetree/bindings/serial/rs485.txt
+++ b/Documentation/devicetree/bindings/serial/rs485.txt
@@ -5,14 +5,13 @@ the built-in half-duplex mode.
 The properties described hereafter shall be given to a half-duplex capable
 UART node.
 
-Required properties:
+Optional properties:
 - rs485-rts-delay: prop-encoded-array <a b> where:
   * a is the delay between rts signal and beginning of data sent in milliseconds.
       it corresponds to the delay before sending data.
   * b is the delay between end of data sent and rts signal in milliseconds
       it corresponds to the delay after sending data and actual release of the line.
-
-Optional properties:
+  If this property is not specified, <0 0> is assumed.
 - linux,rs485-enabled-at-boot-time: empty property telling to enable the rs485
   feature at boot time. It can be disabled later with proper ioctl.
 - rs485-rx-during-tx: empty property that enables the receiving of data even