gpio: revert bank bindings

Keep the words talking about what a GPIO bank is, but remove the
binding. We have not agreed that this is something we want to have.

Acked-by: Rob Herring <robh+dt@kernel.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

diff --git a/Documentation/devicetree/bindings/gpio/gpio.txt b/Documentation/devicetree/bindings/gpio/gpio.txt
index f509ecf03eced0ffd7d83f30b4324d3d361c149b..c88d2ccb05ca97fd1eee27f511f937285a2cadbd 100644 (file)
--- a/Documentation/devicetree/bindings/gpio/gpio.txt
+++ b/Documentation/devicetree/bindings/gpio/gpio.txt
@@ -138,12 +138,6 @@ exposed in the device tree as an individual gpio-controller node, reflecting
 the fact that the hardware was synthesized by reusing the same IP block a
 few times over.
 
-A GPIO controller may specify a bank ID. This is a hardware index that
-indicate the logical order of the GPIO controller in the hardware architecture,
-usually in the sequence 0, 1, 2 .. n. The hardware index may be different
-from the order of register ranges and related to the backplane of how this
-one bank is connected to the outside through a pin controller for example.
-
 Optionally, a GPIO controller may have a "ngpios" property. This property
 indicates the number of in-use slots of available slots for GPIOs. The
 typical example is something like this: the hardware register is 32 bits
@@ -165,7 +159,6 @@ gpio-controller@00000000 {
        reg = <0x00000000 0x1000>;
        gpio-controller;
        #gpio-cells = <2>;
-       gpio-bank = <0>;
        ngpios = <18>;
 }