In wilc_wlan_handle_txq(), mutex unlock was called without acquiring
it. Also error code for full VMM condition was incorrect as discussed in
[1]. Now used a proper code to indicate VMM is full, for which transfer
to VMM is required again. 'wilc_wlan_handle_txq()' should be called
again if the VMM space was full earlier or otherwise based on
'txq_event' signal.
1. https://lore.kernel.org/driverdev-devel/
20191113183322.a54mh2w6dulklgsd@kili.mountain/
Signed-off-by: Ajay Singh <ajay.kathat@microchip.com>
Link: https://lore.kernel.org/r/20200123182129.4053-2-ajay.kathat@microchip.com
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
}
srcu_read_unlock(&wl->srcu, srcu_idx);
}
- } while (ret == -ENOBUFS && !wl->close);
+ } while (ret == WILC_VMM_ENTRY_FULL_RETRY && !wl->close);
}
return 0;
}
struct wilc_vif *vif;
if (wilc->quit)
- goto out;
+ goto out_update_cnt;
mutex_lock(&wilc->txq_add_to_head_cs);
tqe = wilc_wlan_txq_get_first(wilc);
if (!tqe)
- goto out;
+ goto out_unlock;
dev = tqe->vif->ndev;
wilc_wlan_txq_filter_dup_tcp_ack(dev);
i = 0;
}
if (i == 0)
- goto out;
+ goto out_unlock;
vmm_table[i] = 0x0;
acquire_bus(wilc, WILC_BUS_ACQUIRE_AND_WAKEUP);
goto out_release_bus;
if (entries == 0) {
- ret = -ENOBUFS;
+ /*
+ * No VMM space available in firmware so retry to transmit
+ * the packet from tx queue.
+ */
+ ret = WILC_VMM_ENTRY_FULL_RETRY;
goto out_release_bus;
}
out_release_bus:
release_bus(wilc, WILC_BUS_RELEASE_ALLOW_SLEEP);
-out:
+out_unlock:
mutex_unlock(&wilc->txq_add_to_head_cs);
+out_update_cnt:
*txq_count = wilc->txq_entries;
return ret;
}
#define IS_MGMT_STATUS_SUCCES 0x040
#define WILC_WID_TYPE GENMASK(15, 12)
+#define WILC_VMM_ENTRY_FULL_RETRY 1
/********************************************
*
* Tx/Rx Queue Structure