ARM: STi: DT: Add STiH407 family tsin5 pinctrl configuration

tsin5 can only be configured for serial data transfer. However
depending on board design, two alternate tsin5 pin configurations
are available, both in pin-controller-front0.

pinctrl_tsin5_serial_alt1 is brought out on B2120 reference
design as TSD on NIMB slot of the B2004A daughter board.

Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
Signed-off-by: Maxime Coquelin <maxime.coquelin@st.com>

diff --git a/arch/arm/boot/dts/stih407-pinctrl.dtsi b/arch/arm/boot/dts/stih407-pinctrl.dtsi
index 50b5bed50d210f8e2ffd9c38cd573b2f3de8e5b1..f513a29fbf33ff32b790f0b92b7d9940d9dd9406 100644 (file)
--- a/arch/arm/boot/dts/stih407-pinctrl.dtsi
+++ b/arch/arm/boot/dts/stih407-pinctrl.dtsi
@@ -547,6 +547,27 @@ st,pins {
                                        };
                                };
                        };
+
+                       tsin5 {
+                               pinctrl_tsin5_serial_alt1: tsin5_serial_alt1 {
+                                       st,pins {
+                                               DATA7 = <&pio18 4 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+                                               CLKIN = <&pio18 3 ALT1 IN CLKNOTDATA 0 CLK_A>;
+                                               VALID = <&pio18 1 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+                                               ERROR = <&pio18 0 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+                                               PKCLK = <&pio18 2 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+                                       };
+                               };
+                               pinctrl_tsin5_serial_alt2: tsin5_serial_alt2 {
+                                       st,pins {
+                                               DATA7 = <&pio19 4 ALT2 IN SE_NICLK_IO 0 CLK_A>;
+                                               CLKIN = <&pio19 3 ALT2 IN CLKNOTDATA 0 CLK_A>;
+                                               VALID = <&pio19 1 ALT2 IN SE_NICLK_IO 0 CLK_A>;
+                                               ERROR = <&pio19 0 ALT2 IN SE_NICLK_IO 0 CLK_A>;
+                                               PKCLK = <&pio19 2 ALT2 IN SE_NICLK_IO 0 CLK_A>;
+                                       };
+                               };
+                       };
                };
 
                pin-controller-front1 {