qede: VF XDP support

This introduces 2 changes needed for XDP to be supported for VFs:

 a. On VF-side, publish the NDO based on qed outputs

 b. On PF-side, request qed to allocate sufficient cids per-VF
    to allow the child vfs to support it

Signed-off-by: Yuval Mintz <Yuval.Mintz@cavium.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/ethernet/qlogic/qede/qede_main.c b/drivers/net/ethernet/qlogic/qede/qede_main.c
index ad1e24962bdb9604c74e6e0f0bbe7e3372cb05ef..fdf04bc5406e459f2375c9017da67f476048b619 100644 (file)
--- a/drivers/net/ethernet/qlogic/qede/qede_main.c
+++ b/drivers/net/ethernet/qlogic/qede/qede_main.c
@@ -580,6 +580,24 @@ static const struct net_device_ops qede_netdev_vf_ops = {
        .ndo_features_check = qede_features_check,
 };
 
+static const struct net_device_ops qede_netdev_vf_xdp_ops = {
+       .ndo_open = qede_open,
+       .ndo_stop = qede_close,
+       .ndo_start_xmit = qede_start_xmit,
+       .ndo_set_rx_mode = qede_set_rx_mode,
+       .ndo_set_mac_address = qede_set_mac_addr,
+       .ndo_validate_addr = eth_validate_addr,
+       .ndo_change_mtu = qede_change_mtu,
+       .ndo_vlan_rx_add_vid = qede_vlan_rx_add_vid,
+       .ndo_vlan_rx_kill_vid = qede_vlan_rx_kill_vid,
+       .ndo_set_features = qede_set_features,
+       .ndo_get_stats64 = qede_get_stats64,
+       .ndo_udp_tunnel_add = qede_udp_tunnel_add,
+       .ndo_udp_tunnel_del = qede_udp_tunnel_del,
+       .ndo_features_check = qede_features_check,
+       .ndo_xdp = qede_xdp,
+};
+
 /* -------------------------------------------------------------------------
  * START OF PROBE / REMOVE
  * -------------------------------------------------------------------------
@@ -645,10 +663,14 @@ static void qede_init_ndev(struct qede_dev *edev)
 
        ndev->watchdog_timeo = TX_TIMEOUT;
 
-       if (IS_VF(edev))
-               ndev->netdev_ops = &qede_netdev_vf_ops;
-       else
+       if (IS_VF(edev)) {
+               if (edev->dev_info.xdp_supported)
+                       ndev->netdev_ops = &qede_netdev_vf_xdp_ops;
+               else
+                       ndev->netdev_ops = &qede_netdev_vf_ops;
+       } else {
                ndev->netdev_ops = &qede_netdev_ops;
+       }
 
        qede_set_ethtool_ops(ndev);
 
@@ -846,6 +868,12 @@ static void qede_update_pf_params(struct qed_dev *cdev)
        /* 64 rx + 64 tx + 64 XDP */
        memset(&pf_params, 0, sizeof(struct qed_pf_params));
        pf_params.eth_pf_params.num_cons = (MAX_SB_PER_PF_MIMD - 1) * 3;
+
+       /* Same for VFs - make sure they'll have sufficient connections
+        * to support XDP Tx queues.
+        */
+       pf_params.eth_pf_params.num_vf_cons = 48;
+
 #ifdef CONFIG_RFS_ACCEL
        pf_params.eth_pf_params.num_arfs_filters = QEDE_RFS_MAX_FLTR;
 #endif