From 64eb8a15a439b56243697237bab6e2c48281138c Mon Sep 17 00:00:00 2001 From: Alexandru Ardelean Date: Thu, 18 Jan 2018 16:57:40 +0200 Subject: [PATCH] staging: iio: adc: ad7192: disable burnout currents on misconfig The burnout currents can be enabled only if buffer is enabled and CHOP is disabled. So, if neither of these conditions are met, then we should disable the burnout currents in the driver as well, and warn the user. This change doesn't fix anything. The burnout currents simply won't work if CHOP is enabled or buffer is disabled. The intent is to provide the user with some feedback instead of silently not working inside the chip. Signed-off-by: Alexandru Ardelean Signed-off-by: Jonathan Cameron --- drivers/staging/iio/adc/ad7192.c | 6 +++++- 1 file changed, 5 insertions(+), 1 deletion(-) diff --git a/drivers/staging/iio/adc/ad7192.c b/drivers/staging/iio/adc/ad7192.c index f01595593ce2..079a8410d664 100644 --- a/drivers/staging/iio/adc/ad7192.c +++ b/drivers/staging/iio/adc/ad7192.c @@ -290,8 +290,12 @@ static int ad7192_setup(struct ad7192_state *st, if (pdata->unipolar_en) st->conf |= AD7192_CONF_UNIPOLAR; - if (pdata->burnout_curr_en) + if (pdata->burnout_curr_en && pdata->buf_en && !pdata->chop_en) { st->conf |= AD7192_CONF_BURN; + } else if (pdata->burnout_curr_en) { + dev_warn(&st->sd.spi->dev, + "Can't enable burnout currents: see CHOP or buffer\n"); + } ret = ad_sd_write_reg(&st->sd, AD7192_REG_MODE, 3, st->mode); if (ret) -- 2.45.2