From 846137c6a1dba3a7768acb026c45120be5c8cdc1 Mon Sep 17 00:00:00 2001 From: Thierry Reding Date: Mon, 27 May 2019 12:35:05 +0200 Subject: [PATCH] arm64: tegra: Add pin control states for I2C on Tegra186 Two of the Tegra I2C controllers share pads with the DPAUX controllers. In order for the I2C controllers to use these pads, they have to be set into I2C mode. Use the I2C and off pin control states defined in the DT nodes for DPAUX as "default" and "idle" states, respectively. This ensures that the I2C controller driver can properly configure the pins when it needs to perform I2C transactions. Acked-by: Jon Hunter Signed-off-by: Thierry Reding --- arch/arm64/boot/dts/nvidia/tegra186.dtsi | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/arch/arm64/boot/dts/nvidia/tegra186.dtsi b/arch/arm64/boot/dts/nvidia/tegra186.dtsi index 8759fcfaf4ed..0f4eacaf5b77 100644 --- a/arch/arm64/boot/dts/nvidia/tegra186.dtsi +++ b/arch/arm64/boot/dts/nvidia/tegra186.dtsi @@ -173,6 +173,9 @@ dp_aux_ch1_i2c: i2c@3190000 { clock-names = "div-clk"; resets = <&bpmp TEGRA186_RESET_I2C4>; reset-names = "i2c"; + pinctrl-names = "default", "idle"; + pinctrl-0 = <&state_dpaux1_i2c>; + pinctrl-1 = <&state_dpaux1_off>; status = "disabled"; }; @@ -201,6 +204,9 @@ dp_aux_ch0_i2c: i2c@31b0000 { clock-names = "div-clk"; resets = <&bpmp TEGRA186_RESET_I2C6>; reset-names = "i2c"; + pinctrl-names = "default", "idle"; + pinctrl-0 = <&state_dpaux_i2c>; + pinctrl-1 = <&state_dpaux_off>; status = "disabled"; }; -- 2.45.2